SiteBoss S570
The SiteBoss S570 is specifically designed for one particular application:
Remote Cabinet Monitoring and Control - The S570 is a powerful Linux-based hardware product with a number of specialized features. It is specifically designed for use in a DC power environment. Like the rest of the SiteBoss product line, it can be used to monitor environmental conditions, batteries, or other equipment. It is particularly designed to be used in new cellular or broadband wireless sites in Base Tranceiver Stations (BTS) for two purposes. One is that the S570 is to be used specifically as a DC power control device. All the power to the equipment in a remote BTS location is connected through the 10 relays within the S570 unit. This allows the unit to reboot any piece of attached equipment in the remote site. The other purpose, which is common to other SiteBoss products, is remote wireless (GPRS, EDGE) modem connectivity. This allows for connectivity to the remote BTS location should a primary connectivity method, like Microwave backhaul, fail. The combined ability to do DC reboot and wireless modem access to BTS is the primary purpose of this unit.
This brochure describes both the S570 and the newer S570A. The differences in the two units is in the configuration of DC relays on the units.
S570 - Has (10) 500 watt SELV relays. 10amps at up to 60V (peak)
S570A - Has (9) 500 watt SELV relays (same as S570), and replaces one of the S570's (10) 500 watt relays with an 1800 watt relay. 30amps at up to 60V (peak)
The 1800 watt relay in the S570A is specifically designed to work with several prominent WiMAX transceiver manufacturer's equipment which requires switching (re-boot) at 30amps @ -48VDC. The S570A is specifically designed to work in WiMAX base stations that require switching of this type of equipment.
Featured Benefits |
- Control and power-cycle 10 DC devices up to 500 watts each. (S570)
- Control and powercycle 9 DC devices up to 500 watts each, and one device up to 1800 watts (S570A)
- Gain remote access to your cabinets through the S570's optional wireless modem
- Manage and monitor up to 16 non-networked serial devices.
- Detect and trigger responses to up to 1000 serial alarm messages.
- Monitor and control up to 24 sensor inputs and 34 relay outputs including contact closures, voltage inputs, 4-20ma inputs and 10-500 watt relay outputs.
- 802.1Q VLAN support on both Ethernet ports helps you maximize traffic efficiency and administration flexibility.
- IP Routing allows you to access other network devices via the SiteBoss 570 dial-up modem.
|
- Connect up to 16 remote EventSensor™ modules to monitor temperature, humidity, voltage, contact closures, and/or output relays up to 1000 feet away.
- On-board temperature sensor.
- Receive and convert SNMP traps/informs into text alarms.
- Send alarms via TCP/IP to ensure reliable delivery of alarms.
- Send SNMP traps via your dial-up ISP if the Ethernet connection fails. (PPP)
- Send alarms via pager, E-mail, TCP Alert and/or SNMPtrap.
- Compatible with HP Openview®, Spectrum®, Intermapper®, Nagios®, SNMPC®, Netcool®, and all other SNMP-based network management systems.
- Easy-to-understand MIB.
* Note: some features only included on certain models
|
|